Safety Instructions

• DO NOT use near water. Avoid exposing to moisture. The unit is not waterproof, so contact with water could cause permanent damage to the unit as well as electric shock and serious injury to the user. DO NOT use in the rain or under other conditions with high moisture without appropriate protection, and immediately remove power source if exposed to moisture.

WARNING: To reduce the risk of fire or electric shock, do not expose to rain or moisture.

• DO NOT expose to excessive vibration or impact (shock). Be careful not to drop. Internal mechanisms may be damaged by severe shock.
• Clean only using a dry cloth. When cleaning, remember that it is not waterproof and moisture can damage electronic circuitry. DO NOT rinse or immerse, keep dry at all times. DO NOT use soaps, detergents, ammonia, alkaline cleaners, and abrasive cleaning compounds or solvents. These substances may damage lens coatings and electronic circuitry.

CAUTION: Proper ventilation requires a minimum 1/2" (1.25 cm) clearance between ventilation openings and external surfaces. Verify that objects that can block the fan intake and exhaust ports do not impede airflow. Failure to permit adequate airflow may result in overheating of the camera, degraded operation and in extreme situations, damage to the camera.

• DO NOT operate or store near any heat sources such as radiators, heat registers, stoves, or any other apparatus that produce heat. Store in a protected, level and ventilated place. Avoid exposure to temperature extremes, damp, severe vibration, strong magnetic fields, direct sunlight or local heat sources during storage. Remove any batteries from the camera before storage. Recommended storage and usage temperatures are:
  • Operating range: 0°C to 40°C (32°F to 104°F)
  • Storage range: –20°C to 50°C (–4°F to 122°F)
• If there are any performance issues when operating within this temperature range, submit a Support ticket at https://support.red.com.
• Modules and expanders, expanders, and lens mounts are NOT HOT SWAPPABLE, meaning you cannot remove or install these items while the camera is turned on. Before installing or removing these items, you MUST turn off the camera. Failure to do so may result in damage to the item or camera that is not covered under warranty.
• Do not bypass the third prong of the grounding-type plug on the power cord of the DSMC AC Power Adaptor. A grounding-type plug has two blades and a third “grounding” prong. The third prong is provided for your safety. A grounding-type plug shall be connected to an outlet with a protective earthen connection. If the grounding-type plug does not fit into your outlet, do not attempt to modify the plug or outlet, consult a qualified electrician.
• Protect all power cords from being pinched, walked on or driven over by a vehicle. Replace any power cords suspected of sustaining damage due to crushing or other forms of damage.

Products marked with this symbol are class 2 devices. These devices are not provided with a grounding type plug.

CAUTION: The power cord plug for the DSMC AC Power Adaptor is used as the power disconnect. To disconnect all power from the DSMC AC Power Adaptor, unplug the power cord plug from the wall outlet. During use, the power cord plug should remain easily accessible at all times.

• Lithium-ion batteries may be subject to special handling requirements pursuant to federal and local laws. Refer to specific shipping instructions included with your battery regarding proper transport of your battery. Do not handle your battery if it is damaged or leaking. Disposal of batteries must be in accordance with local environmental regulations. For example, California law requires that all rechargeable batteries must be recycled by an authorized recycle center. Storing batteries fully charged or in high temperature conditions may permanently reduce the life of the battery. Available battery capacity may also be temporarily lessened after storage in low temperature conditions.

	WARNING: DO NOT expose the battery to excessive heat.
	WARNING: Danger of explosion if an incorrect battery is charged or used to power the camera and accessories. Replace only with the same or equivalent type battery.
	CAUTION: Refer all service and repair to qualified RED service personnel. To reduce the risk of electric shock, and damage to the camera or accessories, DO NOT attempt to perform any servicing other than any procedures that are recommended in the operating instructions.
	INDOOR USE ONLY: Products marked with this symbol are designed for use indoors only.

Battery Storage and Handling

WARNING: Failure to read, understand, and follow these instructions may result in overheating, chemical leakage, smoke emission, fire, or other potentially harmful results.

• Always follow proper battery handling and storage practices. Improper handling and/or failure to abide by proper storage instructions may cause permanent damage to batteries, or degrade battery charge holding capacity. Improper handling practices or failure to comply with instructions may also put you at risk.
• Lithium-Ion batteries, like the REDVOLT^®, REDVOLT-V™, REDVOLT XL, and RED BRICK^®, self-discharge over time. When storing for long periods of time, store batteries separately from the camera or charger and remember to charge batteries to a capacity level of 40% to 60%. If batteries will be stored for long periods of time, RED recommends that you check the charge level at least once every six (6) months, and recharge batteries to a capacity level of 40% to 60%.
• When not in use, remove the battery from the camera or charger and store the battery in a cool, dry place. Avoid extreme hot temperatures (such as inside a hot car), corrosive gas, and direct sunlight. The optimal storage temperature for batteries is between –20°C to 20°C (–4°F to 68°F).

	WARNING: Batteries stored in a discharged state for long periods of time may self-discharge and lose the ability to hold a charge.
	WARNING: If recharging operation fails to complete even when a specified recharging time has elapsed, immediately stop further recharging.

• Batteries may become warm during charging.
• Discontinue use immediately if batteries become excessively hot, are punctured, begin leaking, or are otherwise compromised. For more information, submit a Support ticket at https://support.red.com.
• RED recommends that you fully charge batteries before the first use. DO NOT overcharge batteries.
• Use of chargers that do not meet RED battery specs, or that apply a higher current to “fast charge” batteries, may degrade the maximum battery capacity and reduce battery life.
• DO NOT disassemble, crush, puncture, short circuit, incinerate, or expose batteries to prolonged temperature above 60°C (140°F).
• DO NOT store batteries in a fully charged state for extended periods of time.
• DO NOT store batteries in a fully discharged state for extended periods of time.
• DO NOT store batteries in the camera, in a camera module, or in a charger for extended periods of time.
• DO NOT use batteries for purposes other than their intended use.
• DO NOT store batteries in extreme hot or cold temperatures.
• DO NOT store batteries in direct sunlight.
• DO NOT use third-party chargers with your RED batteries.
• DO NOT disassemble or modify the battery.
• DO NOT overcharge batteries. Overcharging may increase internal temperature beyond the recommended limits and cause permanent damage to the battery.
• DO NOT connect the positive (+) and negative (–) terminals to a metal object such as a wire.
• DO NOT transport or store the battery together with metal objects such as jewelry, hairpins, etc. as they may generate heat if they come into contact with the battery.
• DO NOT discard the battery into fire or heat.
• DO NOT store, use, or recharge the battery near a heat source such as a fire or a heater.
• DO NOT allow the battery to get wet.
• DO NOT pierce the battery with pointed or other sharp objects.
• DO NOT step on, throw, or strike the battery with a hammer.
• DO NOT use a battery that appears to be deformed or damaged.
• DO NOT directly solder the battery.
• DO NOT put the battery into a microwave oven or a pressurized container.
• DO NOT use or subject the battery to intense sunlight or hot temperatures such as in a car in hot weather.
• DO NOT use it in a location where static electricity may be present.
• DO NOT exceed the recharging temperature range of 0˚C to 40˚C (32˚F to 104˚F).
• RED recommends that you only use RED chargers to recharge RED batteries.
• Store the battery in a location where children cannot reach it.
• If the battery leaks or gives off a bad odor, discontinue use immediately.
• If the battery gives off an odor, generates heat, becomes discolored or deformed, or in any way appears abnormal during use, recharging or storage, immediately remove it from the equipment or battery charger and discontinue use.
• If electrolyte begins leaking from the battery and comes into contact with your skin or clothing, immediately wash it away with running water. Failure to do this may result in skin inflammation.
• If the battery leaks and the electrolyte reaches the eyes, do not rub them. Instead, rinse the eyes with clean running water and immediately seek medical attention. Failure to do this may result in eye injury.
• If you find discoloration, a bad odor due to leakage, overheating and/or other irregularities when using the battery for the first time, submit a Support ticket at https://support.red.com immediately.

NOTE: For more information regarding RED battery charging and instructions for care, refer to our Terms and Conditions.

Shipping Disclaimer

Unless you have been certified to ship dangerous goods, you must work with a Dangerous Goods, Class 9-certified shipper to assist you with a shipment that includes a REDVOLT, REDVOLT-V, REDVOLT XL, and RED BRICK (or other regulated lithium ion batteries). Note that applicable laws prohibit the shipping of batteries that are physically damaged. We urge you to look into the formal rules and regulations of shipping Class 9 Dangerous Goods prior to preparing your shipment. For more information on these regulations, visit www.iata.org and www.dot.gov.